Sony DSR-20MD Mode D'emploi page 35

Notes
• During duplicate, do not change the speed of the player's tape or set it to
pause mode. Otherwise, the time code of the recorded tape becomes out
of sequence and you cannot use it for editing.
• During duplicate, time counter does not appear. Check it in the other
VCR.
• When you start duplicating, the first part of the source tape may be
dropped on the copied tape. Play back the source tape from the preceding
point. You cannot completely copy the tape if the source tape is recorded
from its beginning point.
• You may not be able to copy the first part or an unrecorded portion of the
source tape. Locate the recorded portion on the source tape, then start
copying.
• The recording does not stop the moment you press the x STOP button to
stop editing. The source picture may be recorded a little longer than you
expected.
• If you duplicate a tape by using two DSR-20MD/20MDPs, set DV EE
OUT in the menu of the player to OFF (see page 34).
• The index signals are not recorded when the duplicate starts.
• If you set the REMOTE/LOCAL switch to REMOTE during duplicate,
the tape stops.
Chapter 2 Recording and Playback
31 GB