Sony DSR-20MD Mode D'emploi page 15

5 REMOTE CONTROL S jack
Connect a SIRCS-system remote controller. When
controlling this VCR from a remote controller such as
the DSRM-10 or SVRM-100A (not supplied), connect
the unit to the editing controller via this jack.
Note
SIRCS-system has the same function as
CONTROL S-system.
6 REMOTE FOOT SWITCH
Connect the optional Foot Switch to control this VCR.
Note
The Foot Switch must be conformed with Standard
UL2601-1/EN60601-1.
For details on the Foot Switch, consult with authorized Sony
dealers.
7 LANC jack
When you connect the LANC
the other VCR, you can control this VCR (player) from
the other VCR. The LANC connection transmits
signals such as control signals, time code and time
counter data and status data.
You can control this VCR by connecting the optional
RM-95 Remote Commander to this jack.
Notes
• The other VCR (recorder) receives the time code data
from the LANC jack only when this VCR (player)
is set to show the time code indications.
• If the REMOTE/LOCAL switch is set to REMOTE,
the LANC connection does not transmit signals.
8 RS-232C connector (D-sub 9-pin)
Connect an editing controller or a personal computer
with the RS-232C interface for remote-control of this
VCR.
9 DV jack
The DV jack is i.LINK compatible. Use when the
equipment connected to the VCR has a DV jack.
If you connect the VCR and the other equipment using
DV jacks, you can minimize deterioration of picture
quality during dubbing, editing or capturing still
pictures into a personal computer by digital processing.
For details, refer to the instruction manual of the
equipment you use.
jack
jacks on this VCR and
Note
is a trademark of Sony Corporation and indicates
that this product is in agreement with IEEE1394-1995
specifications and their revisions.
0 ~ AC IN connector
Connect to an AC power outlet using the supplied
power cord.
qa DC IN connector
Connect the optional BP-90A Ni-Cd Battery Pack with
the battery adaptor and DC cable.
Notes
• If the voltage of the Battery Pack falls less than 11 V,
a beep sound is output (when BEEP in the menu is set
to OFF, it is not output) and "dclo" appears in the
display window. Replace the battery by a charged one
or remove it to use the AC power outlet.
• If the voltage of the Battery Pack falls less than
10.5 V, a beep sound is output (when BEEP in the
menu is set to OFF, it is not output) and the VCR is
set to the standby mode. As you cannot turn on the
VCR at this moment, replace the battery by a charged
one or remove it to use the AC power outlet.
qs Equipotential ground terminal
Used to connect to the equipotential plug to bring the
various parts of a system to the same potential.
Refer to "Important safeguards/notices for use in the
medical environment" on page ii.
11 GB
Chapter 1 Overview