Sony DSR-20MD Mode D'emploi page 3

Precautions
Safety
• Operate DSR-20MD only on 120 V AC, 60 Hz.
• Operate DSR-20MDP only on 220 – 240 V AC, 50 Hz.
Check that the unit's operating voltage is identical with your
local power supply.
• If anything falls into the cabinet, unplug the unit and have it
checked by qualified personnel before operating it any
further.
• The unit is not disconnected from the mains as long as it is
connected to the mains outlet, even if the unit itself has
been turned off.
• Unplug the unit from the wall outlet if you do not intend to
use it for an extended period of time. To disconnect the
cord, pull it out by the plug, never by the cord.
• The DC input is to be supplied by Sony Ni-Cd
Rechargeable Battery Pack BP-90A with battery adaptor
and cable. The battery pack is to be recharged by Sony
Battery Charger BC-410*. To comply with UL2601-1 and
IEC60601-1, the battery charger must be located outside
the patient area as described on page ii.
*: BC-410 for DSR-20MD
BC-410CE for DSR-20MDP
Installing
• Allow adequate air circulation to prevent internal heat
buildup.
• This unit is equipped with a fan at the rear. Do not insert
objects nor touch the fan during operation.
• To prevent internal heat buildup, install the unit at least
5 cm away from the wall, and dust the unit periodically.
• Do not place the unit on surfaces (rugs, blankets, etc.) or
near materials (curtains, draperies) that may block the
ventilation slots.
• Do not install the unit near heat sources such as radiators
or air ducts, or in a place subject to direct sunlight,
excessive dust, mechanical vibration or shock.
• Do not install the unit in an inclined position. It is designed
to be operated in a horizontal position only.
• The unit is not designed for portable use. Install it properly
on a flat stable place. Placing it on its side or on a surface
slanted more than 30 degrees may cause damage.
• Keep the unit and cassettes away from equipment with
strong magnets, such as microwave ovens or large
loudspeakers.
• Do not place heavy objects on the unit.
• If the unit is brought directly from a cold to a warm location,
moisture may condense inside the VCR and cause damage
to the video head and tape. When you first install the unit,
or when you move it from a cold to a warm location, wait for
about one hour before operating the unit.
Information
Compatible color systems
The DSR-20MD is designed to record and play back using
the NTSC color system. Recording of video sources based
on other color systems cannot be guaranteed.
Compatible colour systems
The DSR-20MDP is designed to record and play back using
the PAL colour system. Recording of video sources based on
other colour systems cannot be guaranteed.
Caution
Television programs, films, video tapes and other materials
may be copyrighted. Unauthorized recording of such material
may be contrary to the provisions of the copyright laws. Also,
use of this recorder with cable television transmission may
require authorization from the cable television transmission
and/or program owner.
Note
The DSR-20MD/20MDP employs a compression ratio of 5:1,
therefore, images stored by the DSR-20MD/20MDP may not
necessarily retain the full resolution and image information
contained in the original source.
iii GB