Recording Procedure - Sony DSR-20MD Mode D'emploi

Recording Procedure

To record using the optional Foot Switch
Note
When controlling this unit from an editing controller or a personal
computer connected to the RS-232C
LOCAL switch to REMOTE. When not, set the switch to LOCAL (See
page 9).
1
After checking that the cassette's safety switch is set to write enabled
position and the tape for slack, hold the cassette so that the tape
window is facing upward, then insert it into this unit.
For details of the cassette's safety switch, see page 4. For details of checking
the tape for slack, see page 5.
The cassette is automatically drawn into the unit and the tape is wound
round the head drum. The tape is stationary while the head drum
rotates.
2
Press the playback button on the player.
This starts the player's playback operation.
3
Press and hold z REC, and press N PLAY.
This starts the recorder's recording operation.
To stop recording
Press the x STOP button.
1
Press the pedal of the Foot Switch when the VCR is in stop mode.
The VCR starts recording.
2
Press the pedal again.
The recording stops and the VCR goes into recording pause mode.
To stop recording
Press the x STOP button on the VCR.
Notes
• You should set the REMOTE/LOCAL switch to REMOTE to prevent
concurrent use of the foot switch and the front panel controls.
• The beginning of the recording (for about two seconds) cannot be made.
If you immediately start recording, press the pedal twice to go into
recording pause mode, then start recording.
• The Foot Switch must be conformed with Standard UL2601-1/EN60601-
1.
connector, set the REMOTE/
Chapter 2 Recording and Playback
29 GB