Installing Components - Duco Intelli Air Valve Serie Manuel D'utilisation

5A.

Installing components

PAIRING PROCEDURE FOR
ONE VALVE PER ZONE:
(Configurations A en B)
Systems with IQ-unit only:
Activate 'Installer mode' by tapping 'INST' on the IQ-unit. The LED
1a
will flash green rapidly.
Tap once on the iAV Control valve to pair it with the IQ-unit so the
1b
LED flashes green slowly. Tap again so the LED starts to flash
rapidly. Underlying components can now be added in this zone.
Proceed to step
2
Systems without IQ-unit only:
Activate 'Installer mode' by long-pressing 'INST' on the iAV Con-
1
trol valve until the LED starts flashing green rapidly.
Proceed to step
2
For all systems:
Add a control component (RF only) by tapping once on the compo-
2
nent to be paired. The LED will start to flash green rapidly.
Add any underlying window ventilators (RF only) by tapping once
3
on the component to be paired. The LED will flash green slowly.
.
.
ENGLISH
83