Duco Intelli Air Valve Serie Manuel D'utilisation page 85

PAIRING PROCEDURE FOR
MULTIPLE VALVES PER ZONE:
(Configurations C en D)
Systems with IQ-unit only:
Activate 'Installer mode' by tapping 'INST' on the IQ-unit. The LED
1a
will flash green rapidly.
Tap once on the iAV Control valve to pair it with the IQ-unit so the
1b
LED flashes green slowly. Tap again so the LED starts to flash
rapidly. Underlying components can now be added in this zone.
Proceed to step
2
Systems without IQ-unit only:
Activate 'Installer mode' on the master iAV Control valve by
1
long-pressing 'INST' on this iAV Control valve until the LED starts
flashing green rapidly.
Proceed to step
2
For all systems:
Add one control component (User controller, CO
2
Sensor, RF only) by tapping once on any random button on this
component. The LED will start to flash green rapidly.
Set another iAV Control valve to be paired to slave mode by
3
long-pressing up ( ) and down ( ) until the iAV Control valve starts
flashing green slowly.
Tap 'INST' once on this slave iAV Control valve to pair it to the
4
network.
Repeat steps
5
valves in this zone.
.
.
and for the remaining slave iAV Control
3 4
ENGLISH
or Humidity
2
85