06�E Pairing Components; 06�F Removing / Replacing Components - Duco DUCOBOX SILENT 400 Manuel D'installation

ENGLISH
06.E Pairing components
Never pair more than one system with RF components at the same time. If you do so, a component in the wrong
network could be paired, e.g. in the neighbours' DucoBox.
Pairing components on the DucoBox Silent
Activate 'Installer mode' by tapping 'INST' on the DucoBox� The LED
1
will flash green rapidly�
Add control components by tapping once on the component to be
paired� The LED will flash red briefly and then start to flash green
rapidly� Repeat this step until all remaining components in the cur-
rent zone have been paired�
2
With RF components: start with the component closest to the mas-
ter� If the first pairing is unsuccessful, another component may be
tried first, which can then act as a hop point for components which
are unable to make an RF connection with the DucoBox�
Once all components have been paired, 'Installer mode' can be
deactivated by tapping 'INST' on the DucoBox Silent� LEDs on all
3
components will stop flashing�
Please refer to the manual with the components for more detailed informa-
tion�
06.F Removing / replacing components
Paired components can only be removed from the network or replaced within 30 minutes after the component has been paired
or restarted� It can be restarted by powering it down briefly� Remove and replace commands will be ignored after the 30-minute
timeframe� This holds for all components as from production date 170323�
Removing a component
Activate 'Installer mode' by
long-pressing 2 diagonal buttons
1
on a paired control� The LED will
flash green rapidly�
Press once and hold a button on
the component to be removed
2
in order to remove it from the
network�
Deactivate 'Installer mode' by
pressing the 4 buttons on a paired
control simultaneously (or using
3
the palm of your hand on a control
featuring touch buttons)� The LED
will turn white�
28
L0001779-L 18.09.2018 Installation manual for DucoBox Silent
All manuals and user guides at all-guides.com
Replacing a component
5 sec
5 sec
Example of a pairing sequence
2
indicates the sequence in which a
X
component button must be pressed
Activate 'Installer mode' by
long-pressing 2 diagonal buttons
1
on a paired control� The LED will
flash green rapidly�
Press briefly twice on the button
2
of the component to be replaced�
Press briefly once on the button of
the new component� The latter will
3
take on all settings/links in the
network�
Deactivate 'Installer mode' by
pressing the 4 buttons on a paired
control simultaneously (or using
3
the palm of your hand on a control
featuring touch buttons)� The LED
will turn white�
1 8
3 5 7
4 6
5 sec
OLD
twice
NEW
once