Table des Matières
Publicité
EN
PROBLEM
Chain saw does not cut
properly
Bar and chain running
hot and smoking
WARRANTY
EGO WARRANTY POLICY
Please visit the website egopowerplus.com for full terms and conditions of the EGO Warranty policy.
18
56 VOLT LITHIUM-ION CORDLESS CHAIN SAW — CS1400E/CS1600E
CAUSE
◾
Insufficient chain tension.
◾
Dull chain.
◾
Chain installed backwards.
◾
Worn chain.
◾
Dry or excessively stretched chain.
◾
Chain not in bar groove.
◾
Check chain tension for over
tightened condition.
◾
Chain oil tank is empty.
◾
Debris in guide bar groove.
SOLUTION
◾
Readjust the chain tension, following the section:
"ADJUSTING THE CHAIN TENSION".
◾
Sharpen the chain cutters.
◾
Reinstall the saw chain, following the section:
"REPLACE THE BAR AND CHAIN".
◾
Replace the chain, following the section:
"REPLACE THE BAR AND CHAIN".
◾
Check the oil level. Refill the oil tank if necessary.
◾
Reinstall the saw chain, following the section:
"REPLACE THE BAR AND CHAIN".
◾
Re-tension the saw chain; see the section:
"ADJUSTING THE CHAIN TENSION".
◾
Filling bar and chain lubricant.
◾
Clear the debris in the groove.
Publicité
Table des Matières
