Table des Matières
Publicité
1. Position the chain saw on its side with its oil tank cap
facing towards.
2. Clean the cap as well as the area around and then turn it
counterclockwise to remove (Fig. N).
3. Carefully pour the specifically designed oil into the
tank until reaching the bottom of the filter neck.
4. Wipe off any excessive oil and replace the cap.
NOTICE:
With upright position, oil should fill the
inspection window. When the oil is no longer visible in the
inspection window, stop use immediately and refill.
ATTACHING/DETACHING THE BATTERY PACK
Fully charge before first use.
To Attach (Fig. O)
Align the battery ribs with the mounting slots and press
the battery pack down until you hear a "click".
To Detach (Fig. P)
Depress the battery-release button and pull the battery
pack out.
STARTING/STOPPING THE CHAIN SAW
NOTICE:
Before starting the chain saw, check for the oil
level, saw teeth sharpness and properly-working kickback
brake handle. Besides, balanced footing and proper
distance away from the ground are needed.
To Start
1. Pull the chain kickback brake handle towards the
front handle to the operating position (Fig. G).
2. Grasp the front and rear handles firmly, using
both hands.
3. Press down the lock-off button first, then squeeze
the trigger switch to start (Fig. Q). Release the lock-
off button and continue to squeeze the trigger for
continued operation.
WARNING:
Do not attempt to start the saw when the
saw chain is in a cut.
To Stop
1. Release the trigger switch.
2. Push the chain kickback brake handle forward to the
brake position to engage the chain brake (Fig. G).
WARNING:
Always remove the battery pack from the
chain saw during work breaks and after finishing work.
56 VOLT LITHIUM-ION CORDLESS CHAIN SAW — CS1400E/CS1600E
Proper Grip On Handles (Fig. E)
◾
Wear non-slip gloves for maximum grip and protection.
◾
With the saw on a firm, flat surface, hold the saw
firmly with both hands.
◾
Always grasp the front handle with the left hand and
the rear handle with the right.
◾
The fingers should encircle the handle, with the
thumb wrapped under the front handle.
WARNING:
Never use a left-handed (cross-handed)
grip, or any stance which would place your body or arm
across the chain line (Fig. R).
Proper Cutting Stance (Fig. S)
◾
Both feet should be on solid ground, with weight evenly
spread between them.
◾
The left arm should be straight, with the elbow locked.
This helps to withstand the forces generated by
kickback.
◾
Your body should always be to the left of the chain line.
INSTRUCTIONS CONCERNING THE PROPER
TECHNIQUES FOR BASIC FELLING, LIMBING, AND
CROSS-CUTTING
WARNING:
Always be sure of your footing and hold the
chain saw firmly with both hands while the motor is running.
WARNING:
When the saw chain is stopped due
to pinching during cutting, release the trigger switch;
remove the saw chain and guide bar from the wood, then
restart the chain saw.
WARNING:
Do not pull the saw chain with hand
when it is bound by the sawdust. Serious injury could
result if the chain saw starts accidentally. Press the saw
chain against the wood, move the chain saw back and
forth to discharge the debris. Always remove the battery
pack before cleaning. Wear heavy protective gloves when
handling the saw chain.
WARNING:
Never start the chain saw when it is in
contact with the wood. Always allow the chain saw reach
full speed before applying the saw to the wood.
EN
13
Publicité
Table des Matières
