Table des Matières
Publicité
TROUBLESHOOTING
WARNING:
Always protect your hands by wearing heavy gloves when performing any maintenance on the saw
chain. Always remove the battery pack when servicing or transporting the chain saw.
PROBLEM
CAUSE
◾
The battery pack is not attached to
the chain saw.
◾
There is no electrical contact between
the saw and battery.
◾
The battery pack is depleted.
◾
The battery pack or chain saw is
too hot.
◾
The lock-off button is not depressed
before pressing the trigger switch.
Motor does not run
◾
Chain brake is engaged.
◾
Saw chain is bound in the wood.
◾
Debris in bar groove.
◾
Debris in side cover.
◾
Chain does not engage drive sprocket.
Motor runs, but chain
does not rotate
◾
Debris preventing full movement of
the chain kickback brake handle.
Chain brake does not
engage
◾
Possible chain brake malfunction
56 VOLT LITHIUM-ION CORDLESS CHAIN SAW — CS1400E/CS1600E
SOLUTION
◾
Attach the battery pack to the chain saw.
◾
Remove the battery, check contacts and reinstall
the battery pack.
◾
Charge the battery pack.
◾
Allow the battery pack or chain saw to cool until
the temperature drops below 67°C.
◾
Press down the lock-off button and hold it, then
depress the trigger switch to turn on the chain
saw.
◾
Pull the chain kickback brake handle backward
toward the front handle.
◾
Release the trigger switch; remove the saw chain
and guide bar from the wood, then restart the
chain saw.
◾
Press the saw chain against the wood, move
the chain saw back and forth to discharge the
debris.
◾
Remove battery pack, then remove side cover
and clean out debris.
◾
Reinstall the chain, making sure that the drive
links on the chain are fully seated on the
sprocket.
◾
Clean debris from external chain brake
mechanism.
◾
Contact EGO Customer Service.
EN
17
Publicité
Table des Matières
