Setting The Cutting Length; Cutting Hair; Thinning Your Hair - SilverCrest SHBS 600 A1 Mode D'emploi

Setting the cutting length

♦ To set the various cutting lengths, press and hold the release button on the slide
switch
read on the side of the appliance.

Cutting hair

NOTE
► The hair to be cut should be clean and dry.
► Comb the hair carefully to remove any knots.
► Place a hairdressing cape or a cloth around your neck and throat to stop
hair trimmings from falling inside your collar.
► Start by setting the cutting length attachment (
and reduce this in stages while cutting the hair.
► Please note that the corresponding cut length will only be achieved if the
appliance is being held at right angles to the skin surface.
♦ Switch the hair and beard trimmer on by pressing the ON/OFF switch
♦ Run the hair and beard trimmer slowly through your hair.
♦ When doing so, hold the appliance so that the cutting length attachment (
) is as fl at as possible against your scalp.
11
♦ Always cut from your neck towards the top of your head, or from your forehead
and temples upwards towards the middle of your head.
♦ Use the cutter unit
hair very short.

Thinning your hair

The hair and beard trimmer has a thinner attachment
growth.
♦ Push the slide switch for the thinner attachment
position
unit
hair.
♦ Push the slide switch for the thinner attachment
position 0 when you no longer want to use the thinner attachment.
SHBS 600 A1
and slide it to the desired position (1–5). The set cutting length can be
5
without the cutting length attachment (
in order to position the thinner attachment
. The thinner attachment
or
10
2
left as far as the stop to the
3
prevents the cutting unit
2
right as far as the stop to
3
) to a longer length
11
.
6
or
10
or ) to cut the
10 11
to thin out thick hair
in front of the cutting
2
from cutting every
GB
IE
9