Description Of The Appliance; Before Fi Rst Use; Charging The Batteries - SilverCrest SHBS 600 A1 Mode D'emploi

Description of the appliance

Figure A:
Cutting unit
Thinner attachment
2
3 Slide switch for the thinner attachment
Attachment points for cutting length attachment
4
Slide switch for cutting length adjustment with release button
5
On/off switch
6
Charging indicator lamp
7
Connection socket for mains adapter
8
Mains power adapter
9
Cutting length attachment (4/7/10/13/16 mm)
10
Cutting length attachment (18/21/ 24/27/30 mm)
11
Before fi rst use
The hair and beard trimmer can be used as a battery-powered or mains-powered
appliance.

Charging the batteries

The battery for the hair and beard trimmer should be charged for at least
90 minutes before fi rst use.
♦ Plug the cable plug of the mains power adapter
underside of the hair and beard trimmer.
♦ Avoid damaging the appliance! Ensure that the appliance is switched off before
charging the battery.
♦ Plug the mains power adapter
power socket complying with the appliance specifi cations.
♦ The charging progress is indicated by the charging indicator lamp
–
–
–
–
♦ Once the battery is fully charged, you can use the appliance for around
60 minutes without connecting it to the power supply.
SHBS 600 A1
9
Charging indicator lamp fl ashes red: battery is being charged
Charging indicator lamp lights up red: the battery is discharged
Charging indicator lamp fl ashes green: appliance is connected to the
mains power adapter
9
Charging indicator lamp light up green: battery is fully charged
into the socket
9
(wide-range voltage 100–240 V) into a
and charged.
GB
IE
on the
8
.
7
7