Fcc Statement (Applicable In Usa); Ec Declaration Of Conformity - Hilti PD4 Mode D'emploi

en
Printed: 07.07.2013 | Doc-Nr: PUB / 5070017 / 000 / 00
11. FCC statement (applicable in US)
-WARNING-
This equipment has been tested and has been found to com-
ply with the limits for a class B digital device, pursuant to
part 15 of the FCC rules.
These limits are designed to provide reasonable protection
against harmful interference in a residual installation. This
equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio com-
munications. However, there is no guarantee that interfer-
ence will not occur in a particular installation.
If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning
the equipment on and off, the user is encouraged to try to
correct the interference by one or more of the following mea-
sures:
• Re-orient or re-locate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced TV / radio technician
for assistance.
Product information plate
12. EC conformity
Designation:
Type:
Year of design:
In conformance with
We declare, on our own responsibility, that this product com-
plies with the following standards or standardization docu-
ments: EN 50081-1 and EN 61000-6-2 according to the stip-
ulations of the directive 89/336/EEC.
Hilti Corporation
Tassilo Deinzer
Head
Measuring Systems BA
04/2007
24
Laser range meter
PD 4
2006
Reinhard Waibel
Head of Development
Measuring Systems BA
04/2007