Fcc Statement (Applicable In Us) / Ic Statement (Applicable In Canada) - Hilti PMD 200 Mode D'emploi

Trouble or fault
Green laser line is not per-
fectly vertical.
The green laser line and the
red laser dot are not perfectly
superimposed. (Deviations of
+/- 1-2 mm (0.04-0.08 in) are
normal.)
Layout points are not correct
/ existing layout points are
not correct after a reposition-
ing
10 Disposal
WARNING
Risk of injury due to incorrect disposal! Health hazards due to escaping gases or liquids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
Most of the materials from which Hilti products are manufactured can be recycled. The materials must be
correctly separated before they can be recycled. In many countries, your old tools, machines or appliances
can be returned to Hilti for recycling. Ask Hilti Service or your Hilti sales representative for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
11

FCC statement (applicable in US) / IC statement (applicable in Canada)

This device has been tested and found to comply with the limits for a class A digital device, pursuant
to part 15 of the FCC rules. These limits are intended to ensure adequate protection against
electromagnetic interference when the device is operated in areas used for commercial purposes.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause interference to radio communications. The user must
bear costs incurred due to interference that operation of this device in residential areas can cause.
This device is in compliance with paragraph 15 of the FCC rules and the RSS­210 specifications of ISED.
Operation is subject to the following two conditions:
• This device shall cause no harmful interference.
• This device must accept any interference received, including interference that may cause undesired
operation.
20 English
Possible cause
Leveling faulty
Layout tool is experiencing a fault.
Layout tool is experiencing a fault.
Target plate not leveled
Target plate is damaged
The control line is too short
The layout tool was moved
Action to be taken
▶ Switch the layout tool off and
then on again. If the problem
persists, consult Hilti Service.
▶ Switch the layout tool off and
then on again. If the problem
persists, consult Hilti Service.
▶ Switch the layout tool off and
then on again. If the problem
persists, consult Hilti Service.
▶ Make sure that the layout tool is
checked at regular intervals.
▶ Before each marking, level the
target plate with the adjusting
screw.
▶ Check the target plate for
deformation; replace it if
necessary.
▶ Exit the current layout. Repeat
station setting of the layout tool
with a longer control line.
▶ Exit the current layout. Repeat
station setting of the layout tool.
2275630
*2275630*