Connecting The Cables - Niko 10-576 Mode D'emploi

6.1.4. Connecting the cables

• Shorten the cables above the underframe in order to neatly lay the cables.
Ensure that the cables aren't crushed when securing the upper-
and underframe.
• Connect the cables to the plug-in terminal according to the indication.
When doing so, you can take the clamp out of the order.
• Lay the cables in the cable compartment.
PLEASE NOTE! Damage to the device due to overvoltage.
Ensure that all wires are isolated and connected in the cable
compartment (e.g. cable screen).
See the wiring diagram on page 69.
6.1.5. Setting internal unit as end device
The internal unit is at the end of the line or
is the only device on the line:
• Attach the jumper J1 to the two lowest contacts.
Like this, the terminal resistor is in position (image 4).
Upon delivery the terminal resistor is not in position (image 5).
EN
Image 3: Connecting the cables
Image 4: Put terminal resistor into position
Image 5: Terminal resistor upon delivery
10-576
67