Panduit CP-991 Mode D'emploi page 4

© Panduit Corp. 2018
7. Retrofitting ................................................................................................................................. 20
7.1 Changing the cross section .............................................................................................. 20
7.2 Changing the crimping length ........................................................................................... 22
8. Troubleshooting......................................................................................................................... 23
8.1 CP-991 does not run after being switched on ................................................................... 23
8.2 Start process is not being initiated .................................................................................... 24
8.3 Conductor insulation is not removed completely ............................................................... 25
8.4 Ferrule in-feed is disrupted ............................................................................................... 25
The information contained in this manual is based on our experience to date and is believed to be
reliable. It is intended as a guide for use by persons having technical skill at their own discretion and
risk. We do not guarantee favorable results or assume any liability in connection with its use.
Dimensions contained herein are for reference purposes only. For specific dimensional requirements
consult the factory. This publication is not to be taken as a license to operate under, or a
recommendation to infringe any existing patents.
PA29440A01_00 ENG
OPERATION MANUAL
Page: 2 of 26
CP-991 / CP-992
ENGLISH
11-2018