Panduit CP-991 Mode D'emploi page 23

© Panduit Corp. 2018
PA29440A01_00 ENG
OPERATION MANUAL
Changing the reversing base sleeve
CP-991: Change the reversing base
sleeve during a cross section change from
0.5/0.75/1.0/1.5 ↔ 2.5.
CP-992: Change the reversing base sleeve
every time the cross section is changed.
•
Pull the release lever (1) forwards
•
Remove the reversing base sleeve (2) downwards
•
Hold the release lever in the forward position and
attach the reversing base sleeve with the desired
cross section
•
Lock the release lever into place
Changing the sleeve receiver
The sleeve receiver must be changed every
time the cross section is changed.
•
Remove the reversing base sleeve (see Page 21).
•
Pull the sleeve receiver (1) upwards, remove from
the holder and insert into the transport holder (2).
•
Insert the sleeve receiver into the holder using the
desired cross section (3) and push downwards (4).
NOTE: Check for correct lock-in position.
•
Install reversing base sleeve.
Changing the cord-centering funnel
CP-991: The cord-centering funnels must be
changed during a 0.5...1.5 ↔ 2.5 cross section
change.
CP-992: The cord-centering funnels must be
changed every time the cross section is
changed.
•
Remove the reversing base sleeve and sleeve
receiver (see above)
•
Slide the slide (1) upwards and pull the holder (2)
forwards
•
Remove the second holder in the same way
•
Remove both cord-centering funnels (3)
•
Attach the cord-centering funnels onto the driving
pins (5) with the desired cross section (4)
•
Attach the holders (6) and press the slide (7)
downwards
•
Install the sleeve receiver and reversing base sleeve
Page: 21 of 26
CP-991 / CP-992
ENGLISH
11-2018