Control Panel - Panduit CP-991 Mode D'emploi

© Panduit Corp. 2018

4.4 Control panel

Table 4-4
PA29440A01_00 ENG
OPERATION MANUAL
Button functions
Button Display
2 s
5 s
Button function
Select operating mode
Strip only
For testing the incision depth of the blade.
The LED on the button lights up.
Strip and crimp
The LED on the button lights up.
Changing the speed of the feeder bowl
Increases the speed of filling the feeder bowl if
new ferrules have been filled.
Display shows 100%.
The speed of the feeder bowl can be changed
using the arrow buttons. The speed is shown
in percent in the display.
Setting the counter to zero
Pressing the set/reset button for two seconds
resets the counter to zero.
Changing the counting direction
Pressing the set/rest button for five seconds
changes the counting direction. The counting
direction is shown in the display.
Forwards (1, 2, 3, ...)
Backwards (..., 3, 2, 1)
When counting backwards, a checkered flag
appears at 0 items. The device can no longer
be started. Turn the CP-991 off and on again.
The CP-991 changes to forwards mode.
Changing the counter reading with backwards
counting
Press the set/reset button briefly to change the
counter reading. The selected number flashes.
The selected number can be changed using
the plus or minus button.
Another position within the five-digit number
can be selected using the arrow buttons.
To save, press the set/reset button again.
Page: 14 of 26
CP-991 / CP-992
ENGLISH
11-2018