Changing The Crimping Length - Panduit CP-991 Mode D'emploi

© Panduit Corp. 2018

7.2 Changing the crimping length

The crimping length is changed using a rotary dial.
Changing the crimping length
Changing the rotary dial
•
Follow the steps mentioned above to remove the stripping blade and crimping jaws (see
Page 22)
•
Insert the rotary dial (1) at the desired crimping length using a screwdriver
The selected value is shown via the red marker (2).
•
Re-attach individual parts
PA29440A01_00 ENG
OPERATION MANUAL
Changing the stripping blade and crimping jaws
CP-991: No change.
CP-992: The crimping jaws and stripping blade
must be altered during a cross section change.
•
The steps for removing the cord-centering funnels
are mentioned above
•
Take out both of the stripping blades (1 + 2)
•
Slide the cassette (3) upwards
•
Take out both of the crimping jaws (4 + 5)
•
Attach in the reverse order
NOTE: Check for correct lock-in position.
Changing the separation plates
CP-991: The separation plates must be changed
during a 0.5...1.5 ↔ 2.5 cross section change.
CP-992: The separation plate must be changed
during a 4 ↔ 6 ↔ 10 cross section change.
•
Unscrew the separation plate (1) using the hexagonal
wrench and remove (2)
•
Remove the separation plate from the retrofit kit with
the desired cross section and attach in place of the
previous separation plate
Page: 22 of 26
CP-991 / CP-992
ENGLISH
11-2018