Operation Without Dmx Controller; Operation By Means Of The Menu; Colour Spotlight - IMG STAGELINE PARL-5RGBW Mode D'emploi

making sure that no obstacles are between the
GB
remote control and the spotlight.
Please refer to chapter 1.1 for the functions of
the remote control.
To protect the spotlight against inadvertent oper-
ation, switch off infrared reception via the menu
of the spotlight (
3) If the range of the remote control decreases,
replace the batteries: On the rear side of the
remote control, push the small latch with the
groove to the right and pull out the battery sup-
port at the same time.
1.
2.
Ž
Pulling out the battery support
Use the batteries that are specified on the
remote control. Observe the correct polarity
when inserting the batteries (⊕/⊖).
If the remote control is not to be used for a
longer period of time, remove the batteries to
prevent damage to the remote control due to
battery leakage.
Used batteries must not be placed in the
household waste. Always take them to
a special waste disposal (e. g. collection
container at your retailer) for a disposal
that is not harmful to the environment.

6.2 Operation by means of the menu

To make settings by means of the menu, use the
buttons MENU, UP, DOWN and ENTER (7).
1) Press the button MENU repeatedly until the dis-
play does not change anymore: The top menu
level (main menu) has then been reached
( chapter 10.2, left side of the figure).
2) Use the button UP or DOWN to select the menu
item desired.
3) Press the button ENTER. The display will indi-
cate the current setting of the menu item
selected.
4) Use the button UP or DOWN to change the set-
ting.
5) If submenu items are available: Press the button
ENTER to call up the submenu items, and then
use the button UP or DOWN to change their set-
tings.
12
chapter 9.1).
6) To save a setting, wait for the display to extin-
guish. Thus, a change will be retained even after
the power supply was interrupted.
7) Use the button MENU to go back to a higher
menu level for making further settings (if re -
quired, go back to the main menu,
The display will extinguish after a few seconds, if
no button is pressed. It will illuminate again once a
button is pressed.
Make the desired settings for the respective oper-
ating mode, observing chapters 7 to 9.
7

Operation without DMX Controller

7.1 Colour spotlight

In this mode, the spotlight constantly emits light of
an adjustable colour.
Use the remote control to switch the primary
colours individually on and off: Press the appropri-
ate button for white or the primary colour desired:
5/ W = white
7/ R = red
8/ G = green
9/ B = blue
To select one of the 9 predefined colours:
1) Call up the menu item
2) Use the button UP or DOWN to select the colour
desired ( to
To set a specific colour mix:
3) Instead of a predefined colour, select the option
and then press the button ENTER to con-
firm your selection. The following information
will appear on the display: A letter to indicate
the colour to be set ( = red, = green, = blue,
= white) and a value to indicate the current
brightness of the colour.
4) If required, use the button UP or DOWN to
change the brightness value (0 – 255) for the
colour selected.
5) Use the button ENTER to go to the setting of the
next colour.
7.2 Stroboscope
The stroboscope function can be switched on via
the button STROBE on the remote control. To
change the flash frequency, press the button
STROBE or SPEED repeatedly.
step 1).
.
).