Care Of Plated Parts; Door Glass Replacement; Media Tray Installation - Napoleon Oakville Serie Manuel D'installation

maintenance
EN
8.3

care of plated parts

If the appliance is equipped with plated parts, you must clean fi ngerprints or other marks from the plated surfaces
before operating the appliance for the fi rst time. Use an ammonia-free or vinegar-based cleaner and a towel
to clean. If not cleaned properly before operating for the fi rst time, the marks can cause permanent blemishes
on the plating. After the plating is cured, the fi ngerprints and oils will not affect the fi nish and little maintenance
is required, just wipe clean as needed. Prolonged high temperature burning with the door ajar may cause
discolouration on plated parts.
note:
The protective wrap on plated parts is best removed when the assembly is at room temperature but this can
be improved if the assembly is warmed (i.e. using a hair dryer or similar heat source).
8.4

door glass replacement

WARNING
!
• Do not use substitute materials.
• Glass may be hot. Do not touch glass until cooled.
• Care must be taken when removing and disposing of any broken door glass or damaged components. Be
sure to vacuum up any broken glass from inside appliance before operation.
• Do not strike, slam, or scratch. Do not operate appliance with glass removed, cracked, broken, or scratched.
Replacement glass/frame assembly shall be replaced as a complete unit as supplied by the appliance
manufacturer.
8.5

media tray installation

Secure the media tray to the burner using 6 screws (W570-0001).
When removing the media tray, make sure the glass media
is away from the center of the screen, exposing the burner.
Remove screws and lift media tray out.
When replacing the burner, absolutely no glass media can be
surrounding the orifi ce.
hint:
If glass surrounds the orifi ce, insert a clean bag into
a vacuum cleaner and vacuum out glass media.
Replacement glass media can be ordered from Wolf
Steel Ltd.
34
W415-1802 / E / 01.20.20