Gree GWH09QB-K3DNA6C/I Manuel D'utilisation page 23

Malfunction analysis
Phenomenon
● Power failure?
● Is plug loose?
● Air switch trips off or fuse is
Air condit-
● Wiring has malfunction?
ioner can't
● Unit has restarted immediately
operate
● Whether the function setting
Mist is em-
itted from ● Indoor temperature and hum-
indoor unit's
air outlet
● Unit is operating under auto
Set temper-
ature can't
be adjusted
● Your required temperature
● Voltage is too low?
Cooling
● Filter is dirty?
(heating)
● Set temperature is in proper
effect is
not good.
● Door and window are open?
Copyright 2018. This translation is property of GREE PRODUCTS SL. All rights reserved. Total or partial reproduction without its express authorization is prohibited.
Check items
burnt out?
after stopping operation?
for remote controller is
correct?
idity is high?
mode?
exceeds the set temperature
range?
range?
● Wait until power recovery.
● Reinsert the plug.
● Ask professional to replace
air switch or fuse.
● Ask professional to replace it.
● Wait for 3min, and then turn
on the unit again.
● Reset the function.
● Because indoor air is cooled
rapidly. After a while, indoor
temperature and humidity will
be decrease and mist will
disappear.
● Temperature can't be adju-
sted under auto mode.
Please switch the operation
mode if you need to adjust
temperature.
● Set temperature range:
16℃ ~30℃ .
● Wait until the voltage
resumes normal.
● Clean the filter.
● Adjust temperature to proper
range.
● Close door and window.
20
Solution