Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
With your radio, you can use this control signal to expand or compress the dynamic range (the difference
between the loudest and quietaet sounds) of the reproduced audio signal.
Changing the dynamic range can affect the 'loudness' and/or 'quality of sound' of the programme that
you hear so that it will be more suited to your listening conditions and your own personal listening
requirements. E.g. In a noisy environment, where quiet sounds might be swamped, setting the compression
to maximum will 'boost' the quiet sounds, whilst keeping the loudest sounds at their original level.
There are 3 levels of compression: DRC off (no compression, this is the default setting), DRC high (maximum
compression) and DRC low (medium compression).
To adjust DRC, press and hold INFO/MENU to enter the menu, scroll to DRC and enter the sub menu with
PLAY/PAUSE.
Prune
You can remove the DAB stations in the station list that cannot be received in your area. These are listed
with a '?' prefix. Enter the menu (press and hold INFO/MENU) and scroll down to PRUNE.
Display Modes
During DAB operation, every time you press the INFO/MENU button, the display will cycle through the
following display modes: DLS > Signal strength > Programme Type > Ensemble/Multiplex (Group name) >
Frequency > Signal error > Audio Bit Rate > Time > Date > DLS > ...:
•
DLS: Dynamic Label Segment is a scrolling message that the broadcaster may include in their trans-
missions. The message usually includes information such as programme details etc.
•
Signal strength: The display will show a slide bar to indicate the signal strength.
•
Programme type: Describes the style of the currently received programme. If the information is not
available, the display will show "<Programme Type>".
•
Ensemble/Multiplex (Group name): Collection of radio stations that are bundled and transmitted
together in a single frequency. There are national and local multiplexes, local ones contain stations
that are specific to that area.
•
Frequency: The frequency of the present station will be displayed.
•
Signal error: This is displayed as a number between 0-99. It would not be satisfactorily to listen to a
radio station with a signal error rate of 30 or above. Try adjusting the antenna or relocating your radio
to improve reception.
•
Audio bit rate: The display will show the digital audio bit rate being received.
•
Time and date: The time and date will be automatically updated by the broadcasted information; it is
not needed to set the clock manually.
13
www.auna.de
Publicité
Table des Matières
