Nettoyage - Vornado PIVOTC Guide Du Propriétaire

NETTOYAGE

Puisque le ventilateur PIVOTC déplace une importante quantité d'air, il aura besoin
d'être nettoyé régulièrement. Le ventilateur ne contient aucune pièce réparable par
l'utilisateur; il est impossible de l'ouvrir pour le nettoyer. Ne nettoyez jamais l'appareil
d'une façon différente de celle expliquée dans le présent guide d'utilisation.
1. Avant de nettoyer l'appareil, mettez-
le hors tension, puis débranchez-le.
2. Époussetez le ventilateur ou essuyez-
le à l'aide d'un chiffon humide.
3. Utilisez un aspirateur domestique,
équipé de sa brosse, pour éliminer la
poussière accumulée.
Note: Remarque : Le moteur est
lubrifi é en permanence; il n'est donc
pas nécessaire de le graisser.
42 Français
- Do not open appliance housing while product is plugged in. To avoid risk
of shock, all service and/or repairs must be done by a Vornado Authorized
Service Center.
- This product employs overload protection (fuse). A blown fuse indicates
an overload or short-circuit situation. If the fuse blows, unplug the product
from the outlet. Replace the fuse as per the user servicing instructions
(follow product marking for proper fuse rating) and check the product. If the
replacement fuse blows, a short-circuit may be present and the product should
be discarded or returned to an authorized service facility for examination and/
or repair.
User Servicing Instructions
1. Using the product controls, turn off the appliance.
2. Grasp the plug (not the cord) and disconnect from the outlet.
3. Risk of Fire. Replace fuse only with 2.5 Amp, 125 Volt fuse as approved
by Vornado Consumer Service. For an authorized replacement fuse,
please contact Vornado Consumer Service.
4. Once the replacement is received, use a small fl at-head screwdriver to
slide open the fuse cover (located on the plug) (See next page, Fig. A).
5. Remove fuse by using the screwdriver to gently lift each end of the fuse
(See next page, Fig. B).
6. Install the replacement fuse by using the screwdriver to gently push each
metal end of the fuse into the receptacle one at a time. Do not push on
the center of the fuse—it is fragile and may break.
7. Slide the fuse cover closed using the screwdriver. When closed, the
cover should fi t completely in the plug. No part of the cover should
stick out (See next page, Fig. C).
8. Plug your appliance into the outlet and turn the power on.
9. If the replacement fuse blows, a short-circuit may be present and the
product should be discarded or returned to an authorized service facility
English 7