Tristar AC-5413 Mode D'emploi page 45

USER'S MANUAL
1
Split Wall-Mounted Air Conditioner
Convenient timer setting for sleeping,
coming home or the
morning etc.
【 Features of Heating Operations 】
Basic principles and performances
•
The unit absorbs heat from the outdoors air and transfers it indoors to heat the room air. The heating capabilities
through this principle of heat pump vary with the increase/decrease of the temperature outside.
•
It only needs a fairly short time for such hot air circulation system to raise the room temperature.
•
When the outdoor air temperature is very low, the system can be used together with other heating devices. Good
ventilation should be maintained to ensure safety and prevent accidents.
Defrosting
When the outdoor air temperature is very low and humidity is very high, frosting will occur to the heat exchanger of the
outdoor unit, which has negative impacts upon the efficiency of the heating performance. In such case the automatic
defrosting function will come into play. The heating operation will be stopped for 5-10 minutes to defrost.
•
The fans of both outdoor and indoor units are stopped. During the defrosting operation, the pilot light will flash
slowly.
•
During the defrosting, the outdoor unit might generate some steam; it is caused by fast defrosting and is not a
malfunction.
•
Upon the completion of the defrosting process, the heating operation is resumed.
8
How to set the ON timer
following
Press the AUTO START button to set the on timer mode during
1 operation.
Each time the button is pressed, the ON timer mode alternates
between ON and OFF.
Set the time of the timer using the HOUR and MIN buttons.
2 Each time the HOUR button is pressed, the Set time is counted up by
1 hour; each time the "MIN" button is pressed, the set time is counted
by 10 minutes.
• To disable the ON timer:
Press the AUTO START button to disable the timer.
HOW to set the OFF timer
Press the AUTO STOP button to set the OFF timer mode during
operation.
1
Each time the HOUR button is pressed, the set time is counted up by
1 hour.
Each time the MIN button is pressed, the set time is counted up by 10
minutes.
Set the time of the timer using the HOUR and MIN buttons.
2
Each time the HOUR button is pressed, the Set time is counted up by
1 hour; each time the "MIN" button is pressed, the set time is counted
by 10 minutes.
• TO disable the OFF timer:
Press the AUTO stop button to disable the timer.
Timer programming
The On timer and OFF timer can be used in combination. The time of the set
time, which is reached first will operate first (
timer operations.)
• If the current time has not been set, the timer operation cannot work.
mark indicates the order of