Fitting The Underlay, Liner & Fi Lling - Procopi Wewa Rectangle Notice De Montage

FITTING THE UNDERLAY, LINER & FILLING
> >
Underlay
◗
Before spreading the underlay (waterproofi ng pack) over the concrete, make sure
that the surface of the concrete is smooth, fl at and clean. The underlay is precut to
the pool dimensions, no trimming will be necessary. Once laid, smooth out creases
as much as possible.
Liner
Figure 35
◗ Put the liner pack in the pool (caution: it is heavy!). Take the liner out and unfold it
once across the pool and then totally along the length of the pool. Before proceeding
with the fi tting itself, allow the liner to rest for a while so that it becomes more supple,
this will facilitate its installation.
◗
Climb bare foot into the pool, check that the bottom corners of the liner wall are
properly aligned with the corners of the pool structure. The liner corners are marked
and should correspond with the pool corners. It is important to spread the liner out
correctly. Push the upper bead of the liner into the liner locking track, continue the
whole way around the periphery of the pool. Hold the liner in place as you go using
half pegs (supplied with the liner), particularly in the corners.
◗ With the liner correctly hung in place, fi ll the pool with 2 cm of water and smooth out
any creases pushing them from the centre of the pool towards the pool walls. This will
not be possible if the pool is completely empty or too full (more than 2 cm water).
◗ Once creases have been eliminated, continue fi lling the pool until the water level is
5 cm below the return fi tting.
◗
At this point, the fi ltration group should be installed before continuing to fi ll the pool.
Figure 36
Figure 37
CAUTION
Before fi tting the liner,
◗
make sure that the
surfaces are free of
splinters and any other
asperities that could
damage the liner.
◗ The ideal ambient
temperature for fi tting
a liner is between
a 18 and 25°. If the
liner is fi tted in colder
weather, take care to
store it beforehand in a
heated room.
Should the liner need
◗
to be repositioned
while fi tting, never pull
it along the rail. Release
it and reposition it
to avoid the risk of
tearing. (damage of this
type is not covered by
the guarantee).
◗ Before and during
the fi lling, check that
liner is correctly hung,
particularly in the
corners. Leave the half
pegs in position while
fi lling the pool.
63