Control Panel Operation - Friedrich Kuhl SQ05 Manuel D'installation Et D'opération

Let's check out how to control your air conditioner. On the control panel, just above the POWER , is a liquid crystal display (LCD). All of the control panel function
buttons and mode icons can be viewed in Figure 6.
Power On – Press the button to turn on the air conditioner. The power button illuminates to indicate that the power is on. The backlight on the power switch
will automatically dim to 20% intensity after 15 seconds of inactivity. The remote control can also be used to turn power ON / OFF (See Remote Control).
Display – The display is a high ef ciency LCD with a built-in white backlight. The backlight has an automatic two (2) step dim function. After 15 seconds of
inactivity, the display dims to 20% intensity. After an additional 120 seconds, the display switches off. Touching any button automatically changes the display
to full brightness.
There are three control push buttons on each side of the display.
Figure 6
SYSTEM:
Cycles between
HEAT, COOL or
FAN ONLY
FAN MODE:
Sets fan to either:
- Cycle automatically
- Run continuously
FAN SPEED:
Sets fan speed:
LOW, MED, HIGH
or AUTO
(as equipped)
ON / OFF:
Turns unit on/off
8

Control Panel Operation

FAN
ONLY
COOL HEAT
88
AUTO FAN
CONTINUOUS
AUTO SPEED
AUTO SPEED
Automatically selects
best fan cooling speed
FAN SPEED
Selected fan speed
CONTROL
LOCKED
WI-FI
OPERATING (if equipped)
F
C
AM
PM
ON OFF
SET POINT
SCHEDULE
ROOM TEMP
CHECK $MART
FILTER
FILTER
Check / Clean
$MART OPERATING
(if equipped)
TEMPERATURE:
Increment UP
WAIT
TEMPERATURE:
Increment DOWN
SCHEDULE ON
TIMER / SCHEDULE
Turns ON or OFF
TIMER ON
IR WINDOW:
Do not block
2 DIGIT DISPLAY
Shows Setting for:
- Set Point (Temperature)
- Room Temperature
- Clock (AM/PM)
FRR079