Remote Control; Temperature Setting - Friedrich Thru-the-Wall Serie Guide D'installation Et De Fonctionnement

REMOTE CONTROL

POWER
• To turn the air conditioner ON, push this button.
To turn the air conditioner OFF, push the button again.
• This button takes priority over any other button.
• When you first turn it on, the unit is in cool mode, High fan speed,
Temperature setting at 72°F.
• Auto Restart
In the event at a power failure, the unit will run at the previous setting once
power returns.

TEMPERATURE SETTING

• Use this button to automatically control the temperature of the room.
The temperature can be set within a range of 60°F to 86°F by
increments of 1°F.
• The setting appears in the display.
FAN SPEED
• Every time you push this button it advances the setting as follows:
(High Low Med High)
TIMER
- SHUT-OFF TIME
• You will usually use shut-off time while you sleep.
• If unit is running, use Timer to set number of hours until shut-off.
• For your sleeping comfort, once Time is set, the Temperature setting will
rise 2°F after 30 min, and after another 30 min.
• Push Timer button to advance setting from : 1 Hour
.
Hours maximum
- START TIME
• If unit is off, use Timer to set number of hours before unit start.
• Push Timer button to advance setting from : 1 Hour
.
12Hours maximum
MODE
- Push this button to shift mode of operation from COOL
- COOL :
• Fan runs continually for normal cooling operation.
- MONEY SAVER
• The fan stops when the compressor stops cooling.
Approximately every 3 minutes the fan will turn on and the unit will check the room air temperature to
determine if cooling is needed.
- FAN :
• Fan-only operation
.....
2 Hours 12
.....
2 Hours
MONEY SAVER FAN.
7
Power
Temp
Fan Speed
Timer Mode