Standard Operation - Heating Mode8; Standard Operation - Auto Operation - Friedrich M36YJ Manuel Du Propriétaire

Operating Introductions
Standard Operation - Heating Mode
FAN
SPEED
TEMP
What is the three-minute delay function?
It will take time for the product to blow warm air. The delay is to protect the compressor.
The room will be heated with warm air after three minutes when the compressor begins
operation.

Standard Operation - Auto Operation

In this operation mode, the system is automatically operated by the electronic controls.
- You can set the desired temperature between 18°C(64°F) and 30°C(86°F) for Auto Operation mode.
NOTICE
This function properly operates when you use the remote controller matching each model.
8 Multi zone
1
2
OPER
MODE
3
4
If you want to set the heating operation,
press the button. And press the
button.
Set the desired room temperature higher
than the current room temperature.
A click of the button will increase the
desired temperature by 2°F or 1°C.
TEMP
A click of the button will decrease the
desired temperature by 2°F or 1°C.
- Setting temp range : 60°F~86°F(16°C~30°C)
- If the desired temperature is set lower than
the current room temperature, the heating
function will not begin.
If you prees the mode button during the
operation, the operation mode will be
changed in the order of cooling,
dry(dehumidification),heating,auto-operation
and fan operation.
If you press the button, the cooling
operation will stop.
OPER
MODE