Cord Routing Change - Friedrich Kuhl SQ05 Manuel D'installation Et D'opération

Cord Routing Change

Unplug unit.
Your Kühl Q unit will come with the power cord already installed and routed
to the left side of the unit.
For convenience and optimum appearance the direction that the power cord
exits the unit may be changed from left to right by following the procedure
below. Select the exit location on the left or right based on proximity to
the power outlet.
STEP 1.
Remove Decorative Front Cover. (See Figures 18A and 18B)
1 OPEN THE DECORATIVE FRONT COVER
2
LOCATE AND DISCONNECT ELECTRONIC CONTROL POWER CABLE HARNESS.
Figure 18A
1
Figure 18B
26
3
SCREWS ATTACHING DECORACTIVE
FRONT COVER TO UNIT
(4 REQUIRED)
WARNING
Electrical Shock Hazard
Make sure your electrical receptacle has the
same configuration as your air conditioner's
plug. If different, consult a Licensed Electrician.
Do not use plug adapters.
Do not use an extension cord.
Do not remove ground prong.
Always plug into a grounded 3 prong oulet.
Failure to follow these instructions can result in
death, fire, or electrical shock.
REMOVE ELECTRONIC CONTROL
2
POWER CABLE HARNESS
REMOVE 4 SCREWS ATTACHING DECORATIVE
3
FRONT COVER. SAVE TO REINSTALL LATER.
REMOVE DECORATIVE FRONT COVER.
4
STORE IN A SAFE PLACE TO REINSTALL LATER.
(no image)