Hand Control - Etac molift Partner 255 Manuel D'utilisation

General Safety Precautions
Only use accessories and slings that are adjusted
to fit the user, type of disability, size, weight and
type of transfer.
Working pause ratio/Duty Cycle.
Molift Partner 255 should not be run constantly
for more than 2 minutes (with maximum load),
and rest for minimum 18 minutes. Duty Cycle
10%. (Intermittence according to standard ISO-EN
10535)
Before use / Daily check
Inspection to be performed daily or before use:
Make sure lifter has no visible damage, defects
or deformations
Make sure sling bar connection and all detach-
able parts are properly connected and secured
Test emergency stop button and emergency
lowering
Make sure battery indicator is not illuminated
and service light is green
Make sure sling strap does not have visible

Hand control

The Hand control has 4 buttons for lifting and
lowering of lifting arm and leg spread mechanism
in and out.
The Hand control has an indicator
light that will illuminate when battery level is
low and the lifter requires charging
Hand Control 4 buttons
Art. no. 2018004
How to use Molift Partner 255
Safe Working Load
The lifter is marked with Safe Working Load (SWL)
If there are any faults or defects, the lift needs to
be taken out of operation and marked "out of
order"
Lifting Arm - Up / Down
NB! The lifter is most unstable in top position.
Legs - In / Out
NB! Spreded legs gives increased stability and
better access to chair or toilet.
9
Molift Partner 255 / www.etac.com
If maximum load (SWL) differs
between lifter, sling bar and body
support unit, then the lowest
maximum load shall always be used
Molift lifters shall only be used to lift
persons. Never use the lifter to lift or
move objects of any kind.
damage or frays.
Make sure wheels are rolling freely and lifter is
easy to manouvre
Test run lifters operation functions and make
sure lifter does not make any abnormal
sounds