Fitting The Bark Control Collar; Charging The Bark Control Collar - Petsafe PBC17-16000 Manuel D'utilisation

Fitting the Bark Control Collar

Important: The proper fit and placement of your Bark Control collar is
important for effective operation. The contact points must have direct contact
with your dog's skin on the underside of his neck.
1. Make sure that the collar is turned off.
2. Start with your dog standing comfortably (A).
3. Place the collar on your pet so that the PetSafe
logo is right side up and the collar is directly
under your dog's chin. Centre the contact points
underneath your dog's neck, touching the
skin (B). NOTE: It is sometimes necessary to trim
the hair around the contact points to make sure
that contact is consistent.
4. Check the tightness of the collar by inserting one finger between the end
of a contact point and your dog's neck (C). The fit should be snug but
not constricting.
5. Allow your dog to wear the collar for several minutes then recheck the
fit. Check the fit again as your dog becomes more comfortable with
the collar.

Charging the Bark Control Collar

Excessive charging can shorten battery life. Only charge when you see the low battery light.
1. Lift the rubber cover protecting the charging port and connect the charger.
2. Plug the charger into a standard wall outlet. The green LED will appear.
3. Recharges take no more than 5 hours. Although your Bark Control collar should be
partially charged, you will want to fully charge it before using it for the first time. The green
LED is will turn off after charging is complete.
4. When the Bark Control collar is charged, replace the rubber cover.
6
Do not shave the pet's neck as this may increase the risk of skin irritation.
The collar should not be worn for more than 12 hours out of every 24-hour
period. Leaving the collar on too long could lead to skin irritation.
®
B
petsafe.com
A
C