Status Code; Erase Current Tx - Honeywell 301C Manuel De L'utilisateur

Status Code

These screens display transmission or node status and sensor status
for the selected transmitter. This read-only information can assist
service personnel in troubleshooting.
The XNX and XCD gas detectors will report the warning or fault
number (iFaultWarnNumber) in hexidecimal on the third line. These
transmitters will also report the monitoring state (iMonitoringState) in
the fourth line. See the transmitter documentation for interpretation of
fault numbers and monitoring states.
Typical display for XNX or XCD
Typical display for other transmitters

Erase Current Tx

This function allows the configuration to be erased or the Tx address
for the displayed component to be changed.
Note: Selecting erase current Tx only erases the current device entry
Tx Info configuration. No other data is erased.
32