Configuration Options; Important Instructions - Niko 10-363 Information De Produit

10-363
st
1 access code / parameter
(on memory location number 1)
nd- th
1 20 access code
(on memory location number 2 to 20)
nd th
2 -20 access code / parameter
(on memory location number 2 to 20)
Time-out entered code
Blocking time after third time wrong code
Time-out programming mode
Other factory settings: see programming manual function group with display module.

9.2. Configuration options

ExtU address
Relay switch time
Programming lock (ON/OFF)
Switch relay contact with bus door opening protocol
Always first switch on programming mode on power supply and control unit (ON/OFF)
Key confirmation tone (ON/OFF)
Send light switch protocol (ON/OFF)
Access code 1 to 10 and parameters
Load factory settings
* up to 10 codes
** up to 20 codes
10. PROGRAMMING

10.1. Important instructions

• When entered correctly, a positive confirmation tone sounds (
If the input of a command series
( ).
• Unconfirmed entered values expire after 10 sec.
• If a command series is incompatible with the requested syntax or if too many parameters are entered, the entire command series is cancelled and a
negative confirmation tone sounds.
• With each push on the key, the module sounds a short key confirmation tone (
• Confirm by pushing , cancel by pushing
• The factory settings of the 10 code memory locations are shown below in brackets e.g. (FI = 0).
10.2. Legend LED display modes:
Green
Red
32
is interrupted during 10 seconds, the entire series is cancelled. A negative confirmation tone sounds
flashes every 2 sec.
G
sends door opening protocol with ExtU ad-dress, relay
switches
not assigned
sends door opening protocol with ExtU address, relay
switches, dataset inactive
10 sec.
2 min.
2 min.
Manually
x
x
x
x
x
x
x
x *
x
).
).
flashes
G
Service Unit Niko Configuration SW
10-870
-
-
-
-
-
-
-
-
-
ON
G
R
x
x
x
x
x
x
x
x**
x
OFF
EN