Factory Settings - Niko 10-363 Information De Produit

7. CONNECTION OF THE MODULE
Wiring diagram code lock module 10-363, stand-alone mode
1 2 3
4 5 6
7 8 9
0
10-801
8. INITIAL ACTIVATION
8.1. Error detection and indication
When pressing a key (once and only in code lock mode), a visual and acoustic error message sounds. An error signal sounds and the two-tone LED keeps flashing.
The error signal can be heard each time you press the key again.
The visual error indication stays active until the error is corrected.
Causes
a- and P-conductor: switched or short circuit
between a- and P-conductor
a-wire: not connected or without power supply
key is locked
(pressed for longer than 15 sec.)
9. CONFIGURATION

9.1. Factory settings

Operating mode
ExtU address for door opening function
Send light switch protocol (
Audio signal of
push on the key (confirmation tone)
Always first switch on programming mode on power supply and control unit
Programming lock
Master code
Relay switch time
Switch relay upon receipt of the door opening protocol
Central mode
1 st access code (on memory location number 1)
EN
1 3 14
230 V
Display
LED
blinks
orange
-key)
a
>6Ω
15 16 17 24 23
a
Door opener is not included.
Error signal
NO COM NC
b P
25
10-801
b P
Solution
switch the a and P conductor or resolve the short
circuit; module will return to standby
check a-wire connection or power supply, module will
return to standby
release key,
module will return to standby
code lock
0
active
active
active
OFF
serial number of the code lock module
approx. 3 sec.
active
OFF
111
10-363
10-363
31