Factory Settings; Configuration Options - Niko 10-575 Mode D'emploi

5. SETTINGS AND PROGRAMMING
5.1. Configuration
5.1.1. Activate images based on the external unit address
If the installation with this device, apart from external video units, also contains external units without cameras, the monitor
of the 10-575 will not be activated when there is a call from an external audio unit. To make this function work, the potential
external unit addresses were divided into two sections:
External unit addresses 0-31 (*)
External unit addresses from 32 (*) restricted to external audio units
(*) The external video unit limit cannot be extended.

5.1.2. Factory settings

The device is equipped with an EEPROM which comes with the following factory settings:
Serial number for parallel call
Free function key
The default time settings are as follows:
Speaking time from the start of a conversation
Time during which the camera image remains active
Time during which an internal call remains displayed
Time during which the ringtone suppression remains active (after activation with service unit 10-870) 4 min.

5.1.3. Configuration options

Function
Free function key: image key
Free function key: control function 8
Free function key: switching light
Ring tone volume
Choosing ringtones for two door calls (from the main entrance
door), internal calls (from a different internal unit) and multi-floor
calls (from other apartment doors)
Parallel programming
EN
restricted to external video units
1000000
Image key
The monitor will be activated when there is a door
call (initiated from max. 16 external video units)
The monitor will not be activated when there
is a door call
Manual 10-870
– X
– X
– X
X –
– –
– X
10-575
max. 2 min
80 sec
approximately 30 sec.
Niko configuration
software (in
development)
X
X
X
–
X
X
34