How To Use The Remote Control - Friedrich WallMaster WS08 Instructions D'installation Et D'utilisation

How to use the remote control

To start unit
1 POWER - Press the Power button once. The unit will automatically
start in the mode and fan speed it was last left on.
To set mode of operation
2 COOL - Press the Cool button to automatically switch the operat-
ing mode to COOL.
3 FAN ONLY - Press the Fan Only button if you want to run the
fan only.
4 MoneySaver
- Press the Money Saver
®
the MoneySaver feature. This feature cycles the fan with the
®
compressor so that the fan does not run all the time.
To adjust temperature
5 WARMER - Press the
setting.
6 COOLER - Press the
setting.
To adjust fan speed
7 FAN SPEED - Press the Fan Speed button to see the current
setting. Press again to change the fan speed. F1 is the lowest
setting (SLEEP / LOW), F2 is MEDIUM, F3 is HIGH, and SF is
the SMART FAN setting.
To set the hour clock
8 SET HOUR CLOCK - Press the Set Hr. button once to see the
current clock setting. Continue pressing the button until you
arrive at the current time (Hour only). Minutes are not shown on
the display. Make sure that the A.M. / P.M. setting is correct.
6
button to activate
®
Warmer button to raise the temperature
Cooler button to lower the temperature
920-007-12
To set the timer
NOTE: You can set the START and STOP times a minimum of one
hour apart, and a maximum of 23 hours apart.
9 TIMER START - Press Start to view the current start time for
cooling. Continue pressing the START button until you arrive at
the start time you desire. The start time for cooling will then be
set.
10 TIMER STOP - Press the Stop button. Continue pressing the
STOP button until you arrive at the stop time you desire. The
stop time for cooling will then be set.
11 TIMER ON / OFF - Press the On/Off button (under Timer
Operation) to activate (light on) or deactivate (light off) the timer.
Once the on and off times have been selected, they will remain
in memory and cycle daily until changed.
NOTE: If the unit is unplugged or the power is interrupted, the Set Hr.
function must be reset or the Timer On/Off function will not work.
6
2
3
11
9
Additional RC1 wireless remote controls can be
purchased from your Friedrich dealer.
Temperature
Cooler Warmer
Cool
Power
Fan Fan Money
Only Speed Saver ®
Timer Operation
On/Off Start Stop Set Hr.
Figure 3
5
1
4
7
8
10