Inspection And Maintenance Plan - Güde GH 5.6-50 Traduction Du Mode D'emploi D'origine

Inspection and maintenance plan

Regular servicing period
Engine oil Inspection
(10W-40)
Change
Air filter Inspection
Change
Spark plug Inspection
Clean
Change
Carry out the appropriate maintenance in the month specified or after being operated for the number of operating
hours specified, depending on which occurs first.
* Hours of operation
Troubleshooting
Issue
Engine does not start or
starts, but does not run
further.
Ejected shredded material
Performance dropped
Before any
After 1
start-up month
5 h*



Possible causes
Empty fuel tank
No ignition spark
The spark plug is wet from petrol
(oversaturated engine).
Blade is blocked
Oil level sensor
Blade is blunt
Shredder is clogged
After 3 After 6 After 12
months months months
25 h* 50 h* 100 h*


Recommended solution
Fill up the tank;
check to see whether the carburettor
has any fuel;
Check the tank ventilation and punch a
hole in the tank cap with a needle
Clean the spark plugs and ensure that
there is a 0.6 - 0.8 mm electrode gap,
insert them again if possible;
Check the ignition cable;
Have the ignition system checked by a
service centre
Remove the spark plugs, clean and dry
them;
Pull the starter cord several times with
the spark plugs unscrewed
Make sure that the shredder is not
blocked.
Check the oil level, fill up if necessary.
Place the device horizontally.
Sharpen or turn the blade
Switch off the device and clean it.
ENGLISH
39
After 24
months
250 h*

