Honda Power Equipment HSS760A Manuel De L'utilisateur page 63

Battery removal
1.Remove the battery cover. (Page 53)
2.Remove the battery strap from the bottom hook.
3.Remove the negative (–) cable from the battery first, and then
remove the positive (+) cable from the battery.
4.Remove the battery.
Battery charging
Battery charger which is commercially available for 12 V batteries can
be used to charge the battery.
The battery is rated at 11.0 Ah (10hr). Charging current should equal
10% of the battery's ampere-hour rating. A battery charger should be
used that can be adjusted to deliver 1.1 amps.
1.Connect the battery charger following the manufacturer's
instructions.
2.Charge the battery 5-10 hours.
The battery is completely sealed and does not require additional
maintenance such as adding water.
Battery installation
1.Install the battery in its original position.
2.Connect the battery positive (+) cable to the battery positive (+)
terminal first, and tighten the bolt securely.
3.Slide the battery boot over the positive (+) cable and terminal.
4.Connect the battery negative (–) cable to the battery negative (–)
terminal, and tighten the bolt securely.
60