Transporting - Honda Power Equipment HSS760A Manuel De L'utilisateur

Before loading
To move the snow thrower with the engine OFF, pull both steering
control levers against the handlebar to release the transmission and
then push or pull the snow thrower in the desired direction.
1.Loading the snow thrower on a trailer should be performed on a firm,
level surface.
2.Use a loading ramp that is strong enough to support the combined
weight of the snow thrower and the operator:
Weight of snow thrower: Operating weight
ET
110 kg
3.The loading ramp must be long enough so that its slope is 15° (26%)
or less.
4.If the snow thrower is to be transported on a truck having a hood,
check that the distance between the truck bed and hood is 1.5 m or
more. Remove the discharge chute if the distance is less than 1.5 m.
5.Before loading, check that there is sufficient fuel in the tank. The
engine may stall on the ramp if there is little fuel in the tank.
HSS760A
ETD EW
115 kg 100 kg
Length of
Ramp ( )
h
Height (h)

10. TRANSPORTING

EWD
105 kg
2.5 m 3.0 m
65 cm 75 cm
3.5 m
90 cm
55