dirna Bergstrom bycool FLAT CONCEPT Instructions De Montage page 19

CONCEPT
15
Use any original hole of chassis to fasten water
pump to lower part of vehicle, using silentblock,
washer and nut.
A- For passage of hoses and wiring towards
pump, drill a hole (outwards) according to
measures and then seal with silicone.
15
A
16
Inlet hose of pump must be placed at a downward
angle, fastening both hoses (inlet and outlet) with
(2) Ø10 clamps.
17 In case of electric valves, connect wiring going
from sensor of tank float to original valves switch,
situated on original.
A- Blue cable.
B- Brown cable.
35
19
Air conditioning for vehicles
15
17
19
EN
15
16