Care Instructions - medi Manumed active Mode D'emploi

English
Putting on / Taking off
Open the belt strap before putting the support on.
1. Fold back the lower end of the support. The splint is now inserted
into the corresponding pocket on the inside of the support. Pay attention
to the correct alignment of the splint to the pocket.
2. Pull the support over your hand so that you can see the „m" on the back of
your hand.
3. Close the belt strap so that the opening in the belt strap is positioned
over the outer knuckle.
To remove, open the belt strap. Grasp inside the support from the palm.
Pull the support off your hand while pressing against the inside pocket
and splint.
Please note that the first time you put the support on you should be
instructed by qualified personnel.
Adjusting the splint
The splint can be individually adjusted at a temperature of around 200 °C.

Care instructions

Velcro fasteners should be closed for washing. The splint must be removed
before washing. Soap residues, lotions and ointments can cause skin irritation
and material wear.
• Wash the product by hand, preferably using a medi clean detergent, or in
delicate cycle at 30°C using a mild detergent without fabric conditioners.
• Do not bleach.
• Leave to dry naturally.
• Do not iron.
• Do not dry clean.
    
Note on storage
Must be stored dry and at room temperature. Must be protected from the sun
and moisture.
Composition of the material
Polyamide, polyester, elastane