Getting Started; Receiver Installation - Traxxas TQ 3047 Série Mode D'emploi

GETTING STARTED

TQ Radio System Basic Adjustments
Steering Trim
The steering trim knob located on the face of the transmitter
adjusts the neutral (center) point of the steering channel.
If your model pulls to the right or left when the steering
wheel is centered, turn the knob until the model drives straight when the
steering wheel is centered.
Channel Reversing
The TQ 2.4GHz transmitter has been programmed with the correct
servo direction settings for your model and should not require
adjustment. These instructions are for reference and troubleshooting
only.
Reversing a channel reverses the direction of the corresponding servo.
For example, if you turn the steering wheel to the right and the model
turns left, Channel 1 would need to be reversed to correct the servo
direction. Use the following procedures to reverse the steering and
throttle channels, if necessary. Servo reversing should only be required
if you accidentally reset the direction of a channel. Do not reverse the
steering or throttle channels unless necessary.
Steering reversing procedure:
1. Press and hold the SET button on the transmitter for two seconds.
The status LED will flash green.
2. Turn and hold the steering wheel to the full left or full right position
(it does not matter which position you choose).
3. While holding the steering wheel in position, press the SET button to
reverse the channel.
4. The channel is now reversed. Confirm correct servo operation before
running your model.
4 • TQ RADIO SYSTEM
Throttle reversing procedure:
Note: Throttle reversing is often times unnecessary on electric models,
as issues with the throttle can usually be solved by reprogramming the
speed control and/or verifying that the motor is wired correctly. Before
attempting to reverse the throttle channel using the procedure below,
you should first recalibrate the electronic speed control.
1. Press and hold the SET button on the transmitter for two seconds.
The status LED will flash green.
2. Move and hold the throttle trigger to the full forward or full brake
position (it does not matter which position you choose).
3. While holding the throttle trigger in position, press the SET button to
reverse the channel.
4. The channel is now reversed. Recalibrate the speed control and then
confirm correct servo operation before running your model.

Receiver Installation

Refer to the vehicle owner's manual for installation information, wiring
diagrams, and detailed instructions on maintaining a watertight seal.
Use double-sided adhesive foam tape to install the receiver into the
receiver box. Once installed, plug the wires into the receiver.