HSM Multishred one-4-all Mode D'emploi page 9

4 Operation
WARNING
Before switching the machine on,
make sure that you observe all safety
instructions.
• Set the sliding switch for automatic
operation to "ON/AUTO".
ON/AUTO OFF REV
• Only insert one fl oppy disk or
one CD or one credit card or
max. 8 sheets of paper.
Cutting system starts
automatically.
The material is drawn in and de-
stroyed. The cutting device then
switches off.
Only then load the next material.
Swit ching Multishred off
• Set the sliding switch to "OFF".
ON/AUTO OFF REV
09/2011
5 Troubleshooting
Paper jam, device shutdown
ON/AUTO OFF REV
• Set the slider switch to "REV"
After a delay of 2 seconds, the cutting device
runs in reverse and the material is pushed out.
• Set the slider switch to "ON/AUTO" again.
• Do not put in more material than is allowed.
Shredded material container
Check the level in the shredded material con-
tainer and empty it in good time, as otherwise
the function of the cutting device could be im-
paired.
For all other malfunctions, check whether the
cutting head was correctly positioned on the
shredded material container before contacting
our customer service. If the motor was over-
loaded, let the shredder cool down for 30 min-
utes before using it again.
shredstar Multishred one-4-all
english
• If you feed in to much material (for
example 2 CDs overlap in the cut-
ting device), the device switches off
automatically.
9