Nice RMEKIT AXS 3017 Instructions Et Avertissements Pour L'installation Et L'utilisation page 24

D - Storing an ADDITIONAL transmitter
IMPORTANT! – This procedure can only be carried out if the motor is already associated with a transmitter • To carry out the proce-
dure, you must have access to a second transmitter that has already been stored.
The procedure automatically associates a command given to each button present on the transmitter using the following series criteria:
- button s: associated with the Upward command
- button n: associated with the Stop command
- button t: associated with the Downward command
Before you begin this procedure, place the shutter half way.
01. (on the new transmitter) Hold down the n button for 8 seconds and release (in this case the motor does not make any movement).
02. (on the old transmitter) press the n button 3 times, as long as it has been stored.
03. (on the new transmitter) Press the n button once. After a short time, the motor makes 3 movements to confirm storage. Caution! – If the
motor makes 6 movements, this means that its memory is full.
01
New
Note – While this procedure is being carried out, you can cancel the programming at any time by simultaneously holding down the n and t
buttons on the old transmitter, for 4 seconds.
E - Total memory deletion
Before you begin this procedure, place the shutter half way.
01. Hold the n button down and wait for the motor to make 2 movements. After this, release the button.
02. Hold the s button down and wait for the motor to make 3 movements. After this, release the button.
03. Hold the n button down and wait for the motor to make 3 movements. After this, release the button.
04. Hold the t button down and wait for the motor to make 3 movements. After this, release the button.
05. Simultaneously hold down the s and t buttons and wait for the motor to make 5 movements. After this, release the button.
01
5
sec.
04
3
5
sec.
Note – While this procedure is being carried out, you can cancel the programming at any time by simultaneously holding down the n and t
buttons for 4 seconds. Alternatively, do not press any buttons and wait 60 seconds for the motor to make 6 movements.
11 – English
02
8
sec.
Old
02
2
sec.
all
data
03
X 3
0,5
sec.
New
03
3
5
05
5
5
sec.
3
0,5
sec.
3
5
sec.