Nice RMEKIT AXS 3017 Instructions Et Avertissements Pour L'installation Et L'utilisation page 23

01
2
5
sec.
04
Note – While this procedure is being carried out, you can cancel the programming at any time by simultaneously holding down the n and t
buttons for 4 seconds. Alternatively, do not press any buttons and wait 60 seconds for the motor to make 6 movements.
After adjustment, the s button will control raising and the t button will control lowering. The shutter will move within the limits defined by the
two limit switch points.
C - Setting the "H" point, by partial opening/closure
The motor allows you to store up to 30 different positions for partial shutter opening/closure. These "H" points can only be set after setting the "0"
and "1" limit switches. The following procedure allows you to set a single "H" point. Repeat the procedure to store the other "H" points.
Warning – If you wish to change the "H" point previously stored, repeat this procedure, pressing on the button associated with the point at
step 06.
Before you begin this procedure, place the shutter at the "H" point to be stored.
01. Hold the n button down and wait for the motor to make 2 movements. After this, release the button.
02. Hold the n button down and wait for the motor to make 4 movements. After this, release the button.
03. simultaneously hold down the s and t buttons and wait for the motor to make 2 movements. After this, release the button.
04. Fine adjustment of the "H" position: press the s and t buttons briefly to move the shutter to the desired partial point (with each pulse,
the shutter moves a few millimetres).
05. Hold the n button down and wait for the motor to make 3 movements. After this, release the button.
06. To store the FIRST "H" point: On the transmitter used for this procedure simultaneously hold down the s and t buttons and wait
for the motor to make 4 movements. After this, release the button.
To store SUBSEQUENT "H" points: on a new transmitter, not stored, hold down the desired button and wait for the motor to make 4
movements. After this, release the button.
"H" 01
2
5
sec.
04
"H"
fine adjustment
Note – While this procedure is being carried out, you can cancel the programming at any time by simultaneously holding down the n and t
buttons for 4 seconds. Alternatively, do not press any buttons and wait 60 seconds for the motor to make 6 movements.
02
5
sec.
"1"
fine adjustment
02
5
sec.
05
3
5
sec.
03
4
05
"1"
5
sec.
03
4
06
4
5
sec.
2
5
sec.
3
2
5
sec.
English – 10