Nice RMEKIT AXS 3017 Instructions Et Avertissements Pour L'installation Et L'utilisation page 19

05b. Thread the octagonal crown over the motor tube and push it, as far
as the motor head (fig. 8a). Important – slide the crown groove into
the protrusion found on the bushing of the limit switches.
8a
05c. Fit the drive wheel to the self-locking mechanism on the motor shaft, by
matching up the two arrows on the two devices (fig. 8b). Note - if you
wish to disconnect the wheel, press the "Push" button and extract it.
8b
s h
P u
• Measure the motor as shown in fig. 8c.
8c
05d. (fig. 9) Align the adapter groove (a), with that on the drive wheel (b).
Then insert the motor into the roller tube, by sliding the two grooves
a and b in relation to the protrusion (c) found inside the roller tube.
9
05e. (fig. 9a) Screw the supplied screw (self-tapping 3.9 x 13, UNI 8118)
into the tube, at the point where the drive wheel is located inside the
tube (use the measurement carried out in fig. 8c). This step enables
the wheel to be correctly locked with the tube.
Caution! - To determine the exact point to place the screw,
measure as shown below.
9a
XX
06. At the other end, insert the telescopic cap into the tube (fig. 10). Dur-
ing the operation, align groove (d) found on the cap with the groove
(c) found inside of the roller tube.
10
07. Insert the roller on to the pivot of the telescopic cap (fig. 11).
11
08. The tube is now ready to be installed in the case. Caution! – Be-
fore continuing, ensure that the shutter is fully within the edge
guides and that the shutter is completely lowered.
09. Choose the side on which to position the motor head. – For
safety reasons, the motor head and power cable must be positioned
on the side on which the mains power supply is located (fig. 14).
10. Fix the supports intended for the telescopic cap (fig. 12a) and
the motor head (fig. 12b), to the position determined in point 02
(fig. 6). Screws not supplied.
English – 6