Operating Specifications - Foster Country Mode D'emploi

Table des Matières

Publicité

Operating specifications

STARTTIME
ENDTIME
CLOCK
ALARM
General operation
This timer controls the display of the time (with analogue hands) and the operation of the oven (with the
push-knob and indicator icons).
By turning the push-knob you can: set the time, program and start and end of cooking and set alarm
(Minute Minder).
Setting the time
To set the time shown by the clock, briefly press the knob 4 times until the "CLOCK" icon flashes.
Then, to increase or decrease the time displayed in 1-minute intervals, turn the knob clockwise or
counter-clockwise and the minute hand will move in 1-minute intervals either clockwise or counter-
clockwise.
When 10 seconds have elapsed from the last adjustment of the electronic timer, it automatically exits
from time-setting mode.
Manual cooking
When not activated, the timer allows manual cooking by using the main switch of the oven (external to
the device).
ATTENTION: after you have turned on mains power to the timer, you must wait about 2 seconds before
the relay is energized.
Programming the end-of-cooking time
Programming the end-of-cooking time allows you to start immediately and finish cooking automatically
based on the programmed time.
To program the end-of-cooking time, press the knob briefly 2 times until the "END TIME" icon flashes.
To increase or decrease the cooking time in 1-minute intervals, turn the knob clockwise or counter-
clockwise and the minute hand moves by 1 minute clockwise or counter-clockwise.
The "END TIME" icon will flash for 10 seconds after the last turn. The program can be confirmed by
pressing the knob so long as at least 2 minutes of cooking was programmed.
After the program is confirmed, cookingstartsandtheaudiblealarmisautomaticallyactivated. Cooking will
end when "End-of-Cooking Time = Current Time".
STARTTIME
ENDTIME
CLOCK
ALARM
7
STARTTIME
ENDTIME
CLOCK
ALARM
GB

Publicité

Table des Matières
loading

Table des Matières