Dolmar PB-7600.4 Instructions D'emploi page 4

Start the Blower only in accordance with the instructions.
Do not use any other methods for starting the engine (6)!
• Use the blower and the tools supplied only for applications specified.
• Start the blower engine only after the entire tool has been assembled.
Operation of the tool is permitted only after all the appropriate
accessories are attached.
• The engine is to be switched off immediately if there are any engine
problems.
• When working with the blower, always wrap your fingers tightly around
the handle, keeping the control handle cradled between your thumb and
forefinger. Keep your hand in this position to have your machine under
control at all times. Make sure your control handle is in good condition
and free of moisture, pitch, oil or grease.
Always ensure a safe, well-balanced footing.
• Operate the blower in such a manner as to avoid inhalation of the
exhaust gases. Never run the engine in enclosed rooms (risk of
suffocation and gas poisoning). Carbon monoxide is an odorless gas.
Always ensure there is adequate ventilation.
• Switch off the engine when resting and when leaving the blower
unattended. Place it in a safe location prevent danger to others, setting
fire to combustible materials, or damage to the machine.
• Never lay the hot blower onto dry grass or onto any combustible
materials.
• All protective parts and guards supplied with the machine must be used
during operation.
• Never operate the engine with a faulty exhaust muffler.
• Shut off the engine during transport (7).
• Position the blower safely during car or truck transportation to avoid fuel
leakage.
• When transporting the blower, ensure that the fuel tank is completely
empty.
Refueling
• Shut off the engine during refueling (7), keep well away from open flame
(8) and do not smoke.
• Avoid skin contact with petroleum products. Do not inhale fuel vapor.
Always wear protective gloves during refueling. Change and clean
protective clothing at regular intervals.
• Take care not to spill either fuel or oil in order to prevent soil
contamination (environmental protection). Clean the blower immediately
after fuel has been spilt. Allow wet cloths to dry before disposing in
properly, covered container to prevent spontaneous combustion.
• Avoid any fuel contact with your clothing. Change your clothing
immediately if fuel has been spilled on it (fire hazard).
• Inspect the fuel cap at regular intervals making sure that it stays
securely fastened.
• Carefully tighten the locking screw of the fuel tank. Change locations to
start the engine (at least 3 meters away from the place of refueling) (9).
• Never refuel in closed rooms. Fuel vapors accumulate at ground level
(risk of explosions)
• Only transport and store fuel in approved containers. Make sure stored
fuel is not accessible to children.
• Do not attempt to refuel a hot or a running engine.
(6)
Resting
Transport
Refueling
Maintenance
Tool Replacement
(7)
(8)
(9)
4
3 meters