Charging The Battery Pack - Oregon PowerNow CS250 Manuel D'instructions Original

operating the saW

charging the battery pack

Warning: failure to folloW
proper charging procedures
may cause excessive voltage,
excessive current floW, loss
of control during charging,
leakage of hazardous
chemicals, heat generation,
bursting, or fire.
with the charger cord connected to the
charger and plugged into an electrical
outlet, align the grooves in the battery
with the rails on the charger and slide
the battery pack onto the charger until
fully seated (Fig. 8).
Fig. 8
Check the charge-state indicator for
charging conditions .
18
CHAINSAW MODEL CS 250
inserting and releasing
the battery pack
Align the groove in the battery with the
rails inside the battery port. Firmly insert
the battery pack into the chainsaw's
battery port, pressing forward until you
hear a click as it locks into place (Fig. 9).
Fig. 9
To remove the battery pack, lift up on
the battery release and remove the pack
(Fig . 10) .
Fig. 10
OREGON® PowerNow™
AA 0612 - F/N 551309